Golds-gym Maxx Crosswalk 650 User Manual Page 26
- Page / 36
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
25
TROUBLESHOOTING
M
ost treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed. If further assistance is needed, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 11). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 11. IMPORTANT: The treadmill is not
compatible with GFCI-equipped outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the console.
c. Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch
protrudes as shown, the circuit breaker has
tripped. To reset the circuit breaker, wait for five
minutes, and then press the switch back in.
PROBLEM:The power turns off during use
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. If the treadmill still will not run, see the front cover of this manual.
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a
store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off
the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE
INFORMATION MODE on page 20 to turn off the demo mode.
PROBLEM:The display of the console does not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE
POWER CORD. Next, carefully lower the Uprights
(84, 107). Remove the two #8 x 3/4" Screws (3). Note:
A Phillips screwdriver with a shaft at least 8 in. (20
cm) long is needed.
Tripped
Reset
c
3
107
84
3
a
- USER'S MANUAL 1
- TABLE OF CONTENTS 2
- WARNING DECAL PLACEMENT 2
- IMPORTANT PRECAUTIONS 3
- SAVE THESE INSTRUCTIONS 4
- BEFORE YOU BEGIN 5
- ASSEMBLY 6
- OPERATION AND ADJUSTMENT 11
- DANGER: Improper connection 11
- TROUBLESHOOTING 26
- EXERCISE GUIDELINES 28
- WARNING: Before beginning any 28
- ORDERING REPLACEMENT PARTS 36
- LIMITED WARRANTY 36
Related products and manuals for Sports and recreation Golds-gym Maxx Crosswalk 650
(24 pages)Samsung Q844 manuály
Uživatelské manuály a uživatelské příručky pro DVD přehrávače Samsung Q844.
Poskytujeme manuály pdf Samsung Q844 ke stažení zdarma podle typů dokumentů:
Comments to this Manuals